Installing Sensors basing on the iMETOS Bus

The iMETOS sensor bus is a single side RS485 which allows only communication from the sensor to the iMETOS. The last sensor in the row has to initiate the communication after the bus is powered up by the iMETOS. The small PCB in the cable transfers the signal from RS485 back to the controller input level.

 

 Content:

• The Watermark Extension Bus
• The Multiple Temperature and Relative Humidity Bus
• The Multiple Leaf Wetness Sensor Bus
• The Multiple Pressure Switch Bus
• The Multiple Temperature Bus Based on DS1820
• The Multiple Temperature Bus based on PT 1000 Sensors
• The Multiple Enviroscan and TriScan Sensor Bus
• Using Enviroscan and TriScan Sensors on the PI Bus
• Supporting the 05103 Wind Sentry of RMYoung
• Water Level Sensors for Evapotranspiration Pan
• Water level sensors for Water Level Measurement
• Using the Kipp and Zonen CMP3 Globl Radiation sensor
• ECH2O EC-5, EC-10, EC-20LWS
• Connection schema of Decagon 2xHS & 1xMPS1
• Connection Schema of Water Meter PCB
• Connecting AquaSpyProbes

 

---