Supporting the 05103 Wind Sentry of RMYoung

Cabelling of the 05103 will be normally done in the way that this sensor is the only one in a chain or it is the last in the chain. Therefore the PCB of this sensor is only equipped with one connector for the PI-BUS.
For correct mounting the zero position of the wind direction should be in north. The zero position is indicated by an undefined high or undefined low resistance (0 point of the potentiometer indicating the wind direction) The potentiometer can be measured in between the pins indicated as Common Ground and Wind Dire. Signal in the photograph below.



Created by system. Last Modification: Wednesday 18 of September, 2013 15:06:10 GMT by heiner.